Compuprint 4247-Z03 - Manual (Page 82)

Notes:
1. The printer performs a partial reset to put any change to this parameter value
into effect when you exit the Configuration Menu with START or RETURN.
Buffered data will be lost.
2. When changing the value of the Emulation Mode, verify the Data Stream and
the Printer Address you have set.
To change or check the emulation mode, follow these steps:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
IPDS Configuration
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
IPDS Configuration
Emulation Mode
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
Emulation Mode is displayed.
7. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
8. Press START or RETURN to exit the Menu. See “Exiting the configuration
menu” on page 39.
Media Size Priority
This parameter is available only if the IPDS feature is installed, and the IPDS data
stream is selected. It affects the use of the XOH Set Media Size (SMS) order. This
order may be used in the IPDS data stream to set the page size. The Media Size
Priority setting specifies whether XOH-SMS orders take precedence over the
operator panel settings for maximum print position (MPP) and maximum page
length (MPL).
The following values will be displayed in the menu:
Standard The smaller page size values have priority. The page size will be the
intersection (smaller values) of the operator panel settings and the
XOH-SMS X and Y values.
Alternate
(Default) The XOH-SMS order values have priority. If an XOH-SMS order is
present, its values will be used to define the page size instead of the
operator panel settings.
The media size is defined by the MPP and MPL parameters.
To change or check the Media Size Priority, follow these steps:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
66 User's Guide