Compuprint 4247-Z03 - Manual (Page 91)

Perforation Skipping
Use this parameter to create a bottom margin on your printed page, if the host
data stream does not create a bottom margin.
The range of values is 0 to 879 lines, at 8 lpi. The default value is 0.
To change of check perforation skipping, follow these steps:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO . The printer displays
CONFIGURATION MENU
ASCII Configuration
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO . The printer displays
ASCII Configuration
Perforation Skipping
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired Perforation
Skipping value is displayed.
7. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
8. Press START or RETURN to exit the Menu. See “Exiting the configuration
menu” on page 39.
Emulation Mode
You can set Emulation Mode to the following values:
v
4247 (Default)
v 2381 Personal Printer
v 4202 Proprinter III XL
v Epson-FX
Note: The printer performs a partial reset to put any change to this parameter
value into effect when you exit the Configuration Menu with START or
RETURN
. Buffered data will be lost.
To change or check the emulation mode, follow these steps:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
ASCII Configuration
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
ASCII Configuration
Emulation Mode
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
Emulation Mode is displayed.
Chapter 7. ASCII Configuration 75