Compuprint 4247-Z03 - Manual (Page 123)

Chapter 8. Printer Setup
Paper Source . . . . . . . . . . . . . 107
Front Forms Backup . . . . . . . . . . . 108
Rear Forms Backup . . . . . . . . . . . 108
Continuous Forms Linking . . . . . . . . . 109
Form Feed Mode . . . . . . . . . . . . 110
Controlling Tear Off Operations . . . . . . . 110
Using Automatic Eject to Control Forms Eject 111
Using Automatic Restore to Control Restoring of
Forms .
. . . . . . . . . . . . . . 111
Automatic Eject. . . . . . . . . . . . 112
Automatic Restore . . . . . . . . . . . 113
Continuous Forms Eject Mode . . . . . . . . 114
Bar Code Print Direction . . . . . . . . . 114
Graphics Print Direction . . . . . . . . . . 115
Perforation Safety . . . . . . . . . . . . 116
Jam Sensors . . . . . . . . . . . . . . 116
This chapter describes the procedures for checking and changing printer setup
parameters for your 4247 printer. The chapter is divided into sections according to
parameter. Refer to this partial table of contents for parameter and page listings.
Paper Source
The Paper Source parameter defines the current paper source for the printer. The
values displayed on the operator panel depend on the forms devices installed in
the printer. The paper source setting can be set to any of the following values:
Front
(Default) The front paper path is assigned according to the forms tractors installed on
the printer. The front paper path settings apply to the paper loaded with the
tractor already installed on the printer, if the second (optional) tractor is not
installed. If the second (optional) tractor is installed in the printer, the front
paper path settings apply to the paper loaded on this second optional
tractor.
Rear The rear paper path settings apply to the paper loaded with the lower
tractor, when the second (optional) tractor is installed on the printer.
To change or check the Paper Source:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
Printer Setup
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Setup
Paper Source
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
paper source is displayed.
7. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
107