Compuprint 4247-Z03 - Manual (Page 32)

Turning on the printer
1. Turn on the printer, press the power switch to the | position (ON).
2. Wait until the message 4247 appears, all segments (or character elements) of the
LCD on the operator panel display are lighted, and DIAGNOSTICS IN PROGRESS
appears, then is replaced by the READY message.
READY <A>
XXXX FRONT
Where: XXXX indicates the attachment type.
Attention: If, for any reason, the Controller Board was not correctly installed in
the printer, the printer will not work and the following audio/visual symptoms
will occur:
v
The buzzer sounds continuously
v The Operator Panel display is partially filled with solid black boxes
v The Operator Panel LEDs are all lit.
If this is the case, power off the printer, re-seat the Controller Board, and power
the printer on again.
Note: If the printer displays an error message, see “Status codes and recovery
actions” on page 156. Follow the instructions for the Status Code shown on
the display panel.
Changing the display language (from the default, English)
The printer is delivered with English as the default language. Follow this
procedure to change the language in which messages and menu items will appear
in the operator panel display.
1. Press MENU to enter configuration.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays:
CONFIGURATION MENU
Display Language
3. Press ENTER to display the current value.
4. Press SCROLL/MICRO or SCROLL/MICRO until the language you want
is displayed.
5. Press ENTER. An asterisk (*) will be displayed in front of the selected value.
e61a2021
Figure 21. Turning on the printer
16 User's Guide