Rear automatic forms thickness adjustment (afta) – Compuprint 4247-Z03 User Manual
Page 138
3.
Press ENTER.
4.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Adjustments
Front Form Load Position
5.
Press ENTER to display the current value.
6.
Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
Front Form Load Position is displayed.
7.
Press ENTER.
An asterisk (*) is displayed in front of the selected value.
8.
Press START or RETURN to exit the Menu. See “Exiting the configuration
menu” on page 39.
Rear Automatic Forms Thickness Adjustment (AFTA)
This parameter allows you to adjust the distance between the paper and the
printhead for the rear forms path. Forms must be loaded for this adjustment to be
effective. This adjustment can be set to one of the following values:
-5 to +3
The printer automatically adjusts the distance between the forms
and the printhead. Each adjustment corresponds to 0.03 mm (.0012
in.). (The default is 0, which corresponds to a gap of 0.25 mm [.01
in.] from the forms.)
Fixed 1 to 8
Selects a fixed printhead distance value from 1 to 8 in increments
of 0.5 (where each value equals approximately 0.05 mm [.002 in.]).
Default = 0
To change or check the Rear AFTA:
1.
Press MENU.
2.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
Printer Adjustments
3.
Press ENTER.
4.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Adjustments
Rear AFTA
5.
Press ENTER to display the current value.
6.
Press SCROLL/MICRO or SCROLL/MICRO until the desired value for Rear
AFTA is displayed.
7.
Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
8.
Press START or RETURN to exit the Menu. See “Exiting the configuration
menu” on page 39.
122
User's Guide