Comtech EF Data CLO-10 - Manual (Page 120)

CLO-10 Link Optimizer Revision 1
Remote Control MN/CLO-10.IOM
B-8
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for
Command or
Response to
Query
Description of Arguments
Response
to
Command
(Target to
Controller)
Query
(Instruction
Code and
Qualifier)
Response to query
(Target to
Controller)
Restore Holdoff
Time RSH= 3 bytes Command or Query.
The restore holdoff time is the delay when auto mode prepares
to return a unit (previously faulted, now good) back online due
to a different traffic units failure.
RSH=
RSH?
RSH*
RSH#
RSH^
RSH@ RSH? RSH=xxx
(see description of
arguments)
Switch Global
Configuration SGC= 46 bytes Command or Query.
Global configuration of the switch, in the form:
SGC=OBccbbbrrraaaaaaaaaaaaxxxxxxxxxxxxxxxxxxxxxxxx,
where:
SGC =
SGC ?
SGC *
SGC #
SGC ^ SGC? SGC=OBccbbbrrraa
aaaaaaaaaaxxxxxxx
xxxxxxxxxxxxxxxxx
O = Operating Mode
B=Bridge/Backup State, cc traffic unit 1-12
bbb=Backup Hold-off Time
rrr=Restore Hold-off Time
aaaaaaaaaaaa=Active Traffic Unit
xxxxxxxxxxxx = reserved
xxxxxxxxxxxx = reserved same as OPM 1
same as BBU 3
same as BKH 3
same as RSH 3
same as ACT 12
reserved 12
reserved 12