Comtech EF Data CLO-10 - Manual (Page 130)

CLO-10 Link Optimizer Revision 1
Remote Control MN/CLO-10.IOM
B-18
Parameter
Type
Command
(Instruction
Code and
qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
(Target to
Controller)
Query
(Instruction
Code and
Qualifier)
Response to query
(Target to Controller)
CnC Delay
Monitor N/A 5 bytes Query only.
Monitors the estimated delay value of the interferer in
milliseconds.
Example 1: CLO=229.5 (229.5 ms)
N/A CDM? CDM=xxx.xxx
(see description of
arguments)
CnC Freq Offset
Monitor N/A 6 bytes Query only.
Monitors the estimated frequency offset between
desired and interferer will be calculated.
Unit is in kilohertz ( kHz).
Example 1: CFM=+001.0 (1 kHz)
Example 2: CFM=9999.9 (CnC not locked)
N/A CFM? CFM=xxxx.x
(see description of
arguments)
Software Revision N/A 34-37 bytes Query only.
Unit returns the value of the internal software revision
installed in the unit, in the form:
Boot:x.y.z Bulk1:x.y.z Bulk2:x.y.z
or
Boot:x.y.zz Bulk1:x.y.zz Bulk2:x.y.zz
N/A SWR? SWR=Boot:x.y.zz
Bulk1:x.y.zz Bulk2:x.y.zz
(see description of
arguments)
Software
Information N/A variable Query only.
Complete unit software information:
Example: FRW=
Boot:
FW/xxxxx-1- 1.1.1 04/30/07
Bulk1:
FW/11245- 1.1.1 11/11/04
FW/11247-1- 1.1.1 11/11/04
Bulk2:
FW/11245A 1.1.1 11/11/04
FW/11247-1A 1.1.1 11/11/04
N/A FRW? FRW=x…x
(see description of
arguments)
Software Image IMG= 1 byte, value
of 1 or 2 Command or Query.
Current active software image, where:
1=Bulk Image #1 currently active
2=Bulk Image #2 currently active
IMG=
IMG?
IMG*
IMG#
IMG^
IMG? IMG=x
(see description of
arguments)
Serial Number of
Base Unit N/A 9 bytes Query only.
Used to query the 9-digit serial number of the unit in the
form: xxxxxxxxx
N/A SNM? SNM=xxxxxxxxx
(see description of
arguments)