2 front panel operation, 1 select: (top-level) menu, 2 select: config (configuration) – Comtech EF Data CRS-300 User Manual
Page 201
CRS-300 1:10 Redundancy Switch
MN/CRS300.IOM
Front Panel Operation
Revision 19
6–7
6.2 Front Panel Operation
6.2.1 SELECT: (Top-Level) Menu
SELECT: CONFIG INFO
MONITOR STORE/LD UTIL
Use the
◄ ► arrow keys to select from the choices shown, and then press [ENT]. The function
of each menu branch (and the chapter section that provides information on that branch and its
accompanying submenus) is as follows:
Selection
Sect.
Menu Branch Description
CONFIG
6.2.2
(Configuration) Permits you to fully configure the Switch.
INFO
6.2.3
(Information) Permits you to view information on the Switch, without having to go into
configuration screens.
MONITOR
6.2.4
Permits you to monitor the status of the Switch and view the log of stored events for
both the Switch and its attached modems.
STORE/LD
6.2.5
(Store/Load) Permits you to store and to retrieve up to 10 different Switch
configurations.
UTIL
6.2.6
(Utility) Permits you to perform miscellaneous functions, such as setting the Real-time
clock, adjusting the display brightness, etc.
6.2.2 SELECT: CONFIG (Configuration)
CONFIG: MANUAL AUTO[OFF]
OPTIONS REMOTE ACTIVE
Use the
◄ ► arrow keys to select from the choices shown, and then press [ENT]. The submenus
available under the CONFIG menu branch are as follows:
Selection
Sect.
Menu Branch Description
MANUAL
6.2.2.1 Permits you to select which traffic MODEM the Switch should bridge or backup.
AUTO
[OFF/ON]
6.2.2.2 Permits you to turn AUTO mode off or on. The currently selected state is always
shown on this menu
OPTIONS
6.2.2.3
Permits you to set several operating parameters of the Switch that pertain to enabling
or disabling the availability of Traffic Modems, the reporting of faults and time delays
for responding to faults.
REMOTE
6.2.2.4 Permits you to define the remote control settings.
ACTIVE
6.2.2.5 Permits you to activate modems, if a TMI is present.
The Switch may be monitored over the remote control bus at any time. When in
Local mode, however, configuration parameters may only be changed through the