Comtech EF Data CRS-300 - Manual (Page 214)

CRS-300 1:10 Redundancy Switch MN/CRS300.IOM
Front Panel Operation Revision 19
6–20
6.2.4.5 MONITOR: IO
<0100/LRS?
>0100/LRS=1
This display shows actual communication strings between the Switch and the modems:
• Upper line = Switch controller’s outbound messages
• Lower line = Modem’s inbound responses
These are configurations for the Switch itself, not the modems to which it is
attached.
When in this mode, communication is slowed down to enable viewing of messages. This
display should therefore be used for troubleshooting purposes only.
6.2.5 SELECT: STORE/LD (Store or Load Configuration)
STORE/LOAD CONFIG:
STORE LOAD (PRESS ENTER)
Use the ◄ ► arrow keys to select STORE or LOAD, and then press [ENT]. You can store or load
up to 10 different configurations in the Switch’s non-volatile memory.
These are configurations for the Switch itself, not the modems to which it is
attached.
6.2.5.1 STORE/LD: STORE
STORE CONFIGURATION TO
LOCATION: 10 (ENTER)
Use the ▲ ▼ arrow keys to select the location to where the current configuration is to be
loaded, and then press [ENT]. Locations 1 through 10 are available. If the selected location does
not contain a previously stored configuration, this message displays:
YOUR CONFIGURATION HAS
BEEN STORED! (ENTER)
Press [ENT] or [CLR] to return to the previous menu. If, however, the selected location contains
a previously stored configuration, this message displays:
WARNING! LOC 10 CONTAINS
DATA! OVERWRITE? NO YES