Comtech EF Data CRS-300 - Manual (Page 226)

CRS-300 1:10 Redundancy Switch MN/CRS300.IOM
Serial-based Remote Product Management Revision 19
7–10
Parameter Type
Command
(Code and
qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
(Note that all arguments are ASCII numerical codes,
that is, ASCII codes between 48 and 57)
Response to Command
(Target-to-Controller)
Query
(Code and
qualifier)
Response to query
(Target-to-Controller)
Config Load CLD= 1 byte, numerical,
0 to 9
Command only.
Forces the Switch to retrieve the Configuration Memory
location defined by the argument (0 to 9) and to re-program
the Switch with that stored configuration.
CLD= (message OK)
CLD? (received OK, but
invalid arguments found)
CLD* (message OK, but the
memory location does not
contain configuration info)
N/A N/A
Config Store CST= 1 byte, numerical,
0 to 9
Command or Query.
The command forces the Switch to store the its current
configuration in Configuration Memory location defined by
the argument (0 to 9).
Example: CST=4 (Store current configuration in location 4)
WARNING: Use with caution! If the location already
contains data, it will be automatically overwritten. If in doubt,
query the location first. The query returns the contents of
the location.
CST= (message OK)
CST? (received OK, but
invalid arguments found)
CST# (message OK, but
only permitted in Remote
mode)
CST?n
where n is
0 to 9
Returns the same format
as the SGC, with the
form:
CST=xxx....xxx for a
valid config, and
CST* where no valid
config is found
Date DAY= 6 bytes, numerical Command or Query.
The date, in the form ddmmyy (international date
convention), where:
dd = day of the month, between 01 and 31,
mm = month of the year, between 01 and 12, and
yy = year, between 97 and 96 (1997 to 2000, then 2000 to
2096)
Example: DAY=240457 would be April 24, 2057.
DAY= (message OK)
DAY? (received OK, but
invalid arguments)
DAY# (message OK, but
only permitted in Remote
mode)
DAY? DAY=ddmmyy
(see Description of
Arguments)
Equipment ID N/A 4 bytes,
alphanumeric
Query only.
Unit returns information concerning the equipment
identification.
Example: S300
N/A EID? EID=xxxx
(see Description of
Arguments)