1 rmi cards – Comtech EF Data CRS-300 User Manual
Page 39
CRS-300 1:10 Redundancy Switch
MN/CRS300.IOM
Introduction
Revision 19
1–13
Notes (as of April 2007):
1)
Use CRS-316 instead of CRS-315. To maintain older TMIs in the field, Switch
firmware must also support the CRS-315.
2)
Use CRS-336 instead of CRS-335. To maintain older TMIs in the field, Switch
firmware must also support the CRS-335.
3)
Use CRS-306 instead of CRS-305. To maintain older RMIs in the field, Switch
firmware must also support the CRS-335.
4)
For modems where the terrestrial data type is Ethernet, you can use only one
Ethernet port in Single-port Ethernet Bridge Mode, on the modem rear panel (when
using the optional Ethernet interface).
1.3.3.3.2.1 RMI Cards
Figure 1-14. CRS-305 RMI
(PL/11494-1)
DB-25 Male (2X) BNC Male DB-15 Male
HD-50 Female HD-15 Female
Figure 1-15. CRS-306 RMI
(PL/11494-2)
10/100/1000 (2X) BNC Male DB-15 Male
HD-50 Female HD-15 Female
Figure 1-16. CRS-307 RMI
(PL/11494-3)
DB-25 Male DB-15 Male
HD-50 Female RJ-45 HD-15 Female