Comtech EF Data FX Series Administrator Guide - Manual (Page 101)

Comtech EF Data / Stampede
FX Series Administration Guide - Version 6.1.1 101
Chapter: FX Series Remote Specific Settings
Section: FX Series Remote Configuration Settings
MN-FXSERIESADM6 Rev 5
6.2.6 Configuration Notes
Configuring Routed Mode for Two Interfaces
In routed mode, an IP address must be assigned to all in-path interfaces.
This is a two-step process.
1.) You must define two in-path interfaces each with a different IP address and gateway. Normally
both of these interfaces will use VLAN 0. It is a recommended practice to define a comment for
the in-path interfaces that describes both physical and routing aspects of the interface.
2.) You must define two LAN interfaces and then assign them to the in-path interfaces. On the "LAN
Interface Definition" screen you would normally leave the "Untagged in-path interface" field at
the default setting of "None".