Comtech EF Data FX Series Administrator Guide - Manual (Page 104)

Comtech EF Data / Stampede
FX Series Administration Guide - Version 6.1.1 104
Chapter: FX Series Remote Specific Settings
Section: FX Series Remote In-Path Interfaces
MN-FXSERIESADM6 Rev 5
Inbound Bandwidth (Kbps):
This specifies the amount of inbound bandwidth that will be directed to this interface.
Outbound Bandwidth (Kbps):
This field sets the total max outbound rate for all traffic classes of this interface.
In-band Management:
Normally out-of-band management of the FX is accomplished through the management interface,
however in some scenarios, out-of-band management is not feasible and management of the device must
be performed over an in-path interface. If this is the case, only one in-path interface may be used for in-
band management. The default value is disabled.
NOTE: Changing this setting requires a restart of the acceleration service on the “Status->Real-
time Monitor” page.