Comtech EF Data FX Series Administrator Guide - Manual (Page 82)

Comtech EF Data / Stampede
FX Series Administration Guide - Version 6.1.1 82
Chapter: FX Series Network Settings
Section: Redundancy
MN-FXSERIESADM6 Rev 5
7. On Adc2nd browse to:
a) FX Series Application Delivery Controller-> Configuration->Redundancy
Verify that ‘Authentication Key’ matches that shown on the PrimAdc.
Note: If the Keys do not match, copy and paste the Authentication Key from PrimAdc
to Adc2nd then click ‘Save’ on Adc2nd.
It is necessary to reboot both appliances for Redundancy service to run
4.8.4 Synchronizing Configurations in a WCCP Cluster
When multiple FX devices are functioning in a WCCP cluster, each device has unique network settings,
therefore only selected configuration settings are synchronized between the members of the cluster. The
settings which are synchronized include only the following:
· HTTP Application Policies
· L5 Application Policies
· Authorization Realms
· QoS Queue Definitions
· QoS Filters
Of the above, HTTP application policy synchronizations take effect immediately, throughout the cluster,
unless the HTTP policy references a newly defined authorization realm. If an HTTP application policy
references a modified realm then a restart of the acceleration service may be required for the intended
change to take effect. The other settings require a restart of the acceleration service to take effect.