Comtech EF Data FX Series Administrator Guide - Manual (Page 18)

Comtech EF Data / Stampede
FX Series Administration Guide - Version 6.1.1 xviii
Chapter: Using This Document
Section: Release Notes
MN-FXSERIESADM6 Rev 5
Release Notes
Version 6.1.1 Functionality Enhancements
Package Release 6.1 is the latest WANOP firmware for the FX Series platforms. These new features have
been developed in response to customer feedback and market analysis for the purpose of increasing the
interoperability of the FX Series with other CEFD products and to broaden the scope of environments where
FX Series can be deployed.
This release adds the following new features:

Quality of Service
QoS only license is now rate limited at 700 Mbps instead of 500 Mbps
New protocol filter options for SCTP, PTPv1, PTPv3
Added support for VLAN priority in the QoS filters

FAST Codes
This release introduces new “trial license” Fast Codes for 30/60/90 day for Packet
Compression and WANOP.

Reporting
The Status->View Current Status->ACM QOS->By VSAT Modem has two changes.
New column header for 'Queue Name' indicates which queue a filter is directed
'Filter Hits' column header has been changed to 'Filter Matches'
Version 6.1 Functionality Enhancements
These new features have been developed in response to customer feedback and market analysis for the
purpose of increasing the interoperability of the FX Series with other CEFD products and to broaden the
scope of environments where FX Series can be deployed.
This release adds the following new features:

Enhanced QOS Monitor Functionality
CurrentStatus-> ACM QOS-By VSAT modem.
This now shows ingress packets and bytes which will be non-zero if packet compression is
happening.
CurrentStatus->ACM QOS-Throughput by QOS Queue.
This now shows packet compression savings percentage.
Configuration->QOS-Queues pick list.
This function has been dramatically reworked. You can now change CIR, MIR, Priority, and
enable/disable packet compression directly from the view.

Enhanced SNMP Functionality
MIB
Entirely new MIB which allows full management of the FX.
Same MIB is used for both FX-Remote and ADC.
New wramp SNMP configuration wizard