Comtech EF Data FX Series Administrator Guide - Manual (Page 50)

Comtech EF Data / Stampede
FX Series Administration Guide - Version 6.1.1 50
Chapter: FX Series Network Installation Patterns
Section: FX Series Installation Pattern (WCCP)
MN-FXSERIESADM6 Rev 5
3.3 FX Series Installation Pattern (WCCP)
3.3.1 Cable the Appliance
Connect the eth2 (LAN) port to a switch or a router.
3.3.2 Configure the Appliance
Login to the appliance through the browser interface at: http://{IP_address_of_the_appliance}:10000
6. Enter the default user name “comtech” and the default
password “comtech”.
a. Click Login.
7. Click Configuration -> General Settings
c. Change “Traffic interception mode” to “WCCP”
d. Click Save
8. Click In-Path Interfaces
a. Click the Add button to add a new in-path
interface.

Enter the VLAN ID of 0.

Enter the IP Address.

Enter the Netmask

Enter the Gateway

Enter any static routes needed in the
“Routes” field.
b. Click “Add In-Path Interface”
c. Click the “Return to Configuration” link
9. Click on LAN Interfaces.
a. Click on the “Add” button to add a new LAN
interface.
 Select “eth3” in the “Physical interface”
selection box.

In the “In-Path Interface(s)” selection box,
click the IP address of the in-path interface
*see above*.

In the “Untagged in-path interface”
selection box, select the IP address of the
in-path interface *see above*.
b. Click “Add LAN Interface”.
c. Click the “FX Series Administration Index” link
at the top of the page.
d. Click “Status”, then click “Real-Time Monitor”,
then click “Restart Service”.
e. Click the “FX Series Administration Index” link
at the top of the page.
f. Click “Configuration”
10. Click “WCCP”