Comtech EF Data FX Series Administrator Guide - Manual (Page 59)

Comtech EF Data / Stampede
FX Series Administration Guide - Version 6.1.1 59
Chapter: FX Series Network Settings
Section: In-Path Interface
MN-FXSERIESADM6 Rev 5
4.4 In-Path Interface
These settings allow you to maintain in-path interfaces. A list of previously defined in-path interfaces are
displayed in the order in which they were defined. An existing entry may be chosen by clicking on the IP
Address. The user adds interfaces by clicking the “Add” button. Interfaces can be “enabled” or “disabled”
by checking box to the left of the IP address and clicking on the enable or disable button. Clicking on the
Interface “Name” will allow you to modify that Interface. Each of those actions will then lead to an In-
Path Interface screen.
Figure 4-4 FX Series In-Path Interfaces Definition Screen
4.4.1 In-Path Interface Definition
VLAN ID:
If this interface carries tagged VLAN traffic, then enter the VLAN ID number which is a value between 2
and 4094. Untagged traffic should have a value of 0. The default is 0.
Address:
This is the IPv4 address of this interface.
Netmask: