Comtech EF Data SMS-758 - Manual (Page 130)

Remote Control Operation SMS-758 Modem Protection Switch
A–8 MN/SMS758 Rev. 3
A.3.4.1.2 Backup Modulator Configuration Status
The Backup Modulator Configuration Status command causes a block of data to be
returned by the SMS-758. The block of data reflects the stored configuration of the
modulator selected.
Command: <add/MCS_Bx”cr”
Response: >add/MCS_Bx”cr”
MA_yyy”cr” M od Active (YES/NO)
ADD_yyy”cr” M odem Address
INT_y”cr””lf”] M odem Interface Type
Where: x = 1 or 2 (backup modem number).
A.3.4.1.3 Prime Demodulator Configuration Status
The Prime Demodulator Configuration Status command causes a block of data to be
returned by the SMS-758. The block of data reflects the stored configuration of the
demodulator selected.
Command: <add/DCS_x”cr”
Response: >add/DCS_x”cr”
DA_yyy”cr” D emod Active (YES/NO)
MP_y”cr” M odem Priority (1, 2, or 3)
DT_y”cr” D emod Transponder
MD_yyy.y”cr” M odem Delay
ADD_yyy”cr” M odem Address
INT_y”cr””lf”] M odem Interface Type
Where: x = 1 to 8 (prime demodulator number).
A.3.4.1.4 Backup Demodulator Configuration Status
The Backup Demodulator Configuration Status command causes a block of data to be
returned by the SMS-758. The block of data reflects the stored configuration of the
modulator selected.
Command: <add/DCS_Bx”cr”
Response: >add/DCS_Bx”cr”
DA_yyy”cr” D emod Active (YES/NO)
ADD_yyy”cr” M odem Address
INT_y”cr””lf”] M odem Interface Type
Where: x = 1 or 2 (backup demodulator number).