Comtech EF Data SMS-758 - Manual (Page 155)

SMS-758 Modem Protection Switch Remote Control Operation
MN/SMS758 Rev. 3 B–11
B.3.4.3 Demodulator Status
The demodulator status is returned as a block of data which provides basic status
information of all “active” demodulators. B1 and B2 are the backup demodulators.
Command: <add/DS_”cr”
Response: >add/DS_”cr”
DMD_1_yyy”cr”
DMD_2_yyy”cr”
DMD_3_yyy”cr”
DMD_4_yyy”cr”
DMD_5_yyy”cr”
DMD_6_yyy”cr”
DMD_7_yyy”cr”
DMD_8_yyy”cr”
DMD_B1_yyy”cr”
DMD_B2_yyy”cr””lf”]
Where: yyy = OK or FLT.
B.3.4.4 Prime Modem Fault Status
Command: <add/MFS_x”cr”
Response: >add/MFS_x”cr”
MOD_xxx”cr” mod status (OK/FLT)
DMD_xxx”cr””lf”] demod status (OK/FLT)
Where: x = 1 to 8 (prime modem number).
B.3.4.5 Backup Modem Fault Status
Command: <add/MFS_Bx”cr”
Response: >add/MFS_Bx”cr”
MOD_yyy”cr” mod status (OK/FLT)
DMD_yyy”cr””lf”] demod status (OK/FLT)
Where: x = 1 or 2 (backup modem number).
B.3.4.6 Firmware Version Status
Command: <add/VER_”cr”
Response: >add/VER_x.xxx”cr””lf”]
Where: x.xxx = Firmware version number.