B.3.4 status commands/responses, B.3.3.4 backup modem interface type, B.3.4.1.2 backup modulator configuration status – Comtech EF Data SMS-758 User Manual
Page 152
Remote Control Operation
SMS-758 Modem Protection Switch
B–8
MN/SMS758 Rev. 3
B.3.3.4 Backup Modem Interface Type
Command:
<add/INT_Bx_y”cr”
Response:
>add/INT_Bx_y”cr””lf”]
Status Only:
<add/INT_Bx”cr”
Response:
>add/INT_Bx_y”cr””lf”]
Where:
x = 1 or 2 (backup modem number).
y = 1 (for 15 D), 2 (for V.35), 3 (for RS-422), 4 (for DCTN), 5 (for IDR),
6 (for OTHER), 7 (for IBS), 8 (for D&I), or 9 (for IDR 2:N).
B.3.4 Status Commands/Responses
B.3.4.1 Configuration Status
B.3.4.1.1 Prime Modulator Configuration Status
The Modulator Configuration Status command causes a block of data to be returned by
the SMS-758. The block of data reflects the stored configuration of the modulator
selected.
Command:
<add/MCS_x”cr”
Response:
>add/MCS_x”cr”
MA_yyy”cr”
mod active (YES/NO)
MP_y”cr”
mod priority (1, 2, or 3)
MD_yyy.y”cr”
mod online delay
ADD_yyy”cr”
modem address
INT_y”cr””lf”]
modem interface type
Where: x = 1 to 8 (prime modulator number).
B.3.4.1.2 Backup Modulator Configuration Status
The Modulator Configuration Status command causes a block of data to be returned by
the SMS-758. The block of data reflects the stored configuration of the modulator
selected.
Command:
<add/MCS_Bx”cr”
Response:
>add/MCS_Bx”cr”
MA_yyy”cr”
mod active (YES/NO)
ADD_yyy”cr”
modem address
INT_y”cr””lf”]
modem interface type