Comtech EF Data SMS-758 - Manual (Page 136)

Remote Control Operation SMS-758 Modem Protection Switch
A–14 MN/SMS758 Rev. 3
A.3.5.6.2 Verify Prime Modem Configuration
Command: <add/VMC_x”cr”
Response: >add/VMC_x”cr”
MOD_x_yyy”cr”
DMD_x_yyy”cr””lf”]
Where:
x = 1 to 8 (prime modem number).
yyy = OK or FLT.
A.3.5.6.3 Verify Backup Modem Configuration
Command: <add/VMC_Bx”cr”
Response: >add/VMC_Bx”cr”
MOD_Bx_yyy”cr”
DMD_Bx_yyy”cr””lf”]
Where:
x = 1 or 2 (backup modem number).
yyy = OK or FLT.
A.3.5.7 Operational Status Commands (Faults)
A.3.5.7.1 Modulator Operational Faults Status
Command: <add/MOF_”cr”
Response: >add/MOF_”cr”
BU_OP_FLT_xxxxxxxx”cr””lf”] Backup operation faults (see Note)
Where: x = 1 to 8 (prime mod number).
Note: Fault status data is only returned if fault conditions exist.
A.3.5.7.2 Demodulator Operational Faults Status
Command: <add/DOF_”cr”
Response: >add/DOF_”cr”
BU_OP_FLT_xxxxxxxx”cr” Backup operation faults (see Note)
DL_FLT_yyy”cr””lf”] All Demods on downlink “y” faulted (see Note)
Where:
x = 1 to 8 (prime demod number).
y = 1, 2, 3, or 4 (faulted downlink number).
Note: Fault status data is only returned if fault conditions exist.