B.3.2.3 prime demodulator transponder, B.3.2.4 prime demodulator online delay, B.3.2.5 backup demodulator active – Comtech EF Data SMS-758 User Manual
Page 150
Remote Control Operation
SMS-758 Modem Protection Switch
B–6
MN/SMS758 Rev. 3
B.3.2.3 Prime Demodulator Transponder
Command:
<add/DT_x_y”cr”
Response:
>add/DT_x_y”cr””lf”]
Status Only:
<add/DT_x”cr”
Response:
>add/DT_x_y”cr””lf”]
Where:
x = 1 to 8 (prime demodulator number).
y = 1, 2, 3 or 4 (transponder number, four transponders option).
y = 1, 2, 3, 4, 5, 6, or 7 (transponder number, seven transponders option).
Note: See the “DTO_” command for the definition of downlink transponder option.
B.3.2.4 Prime Demodulator Online Delay
Command:
<add/DD_x_yyy.y”cr”
Response:
>add/DD_x_yyy.y”cr””lf]
Status Only:
<add/DD_y”cr”
Response:
>add/DD_x_yyy.y”cr””lf]
Where:
x = 1 to 8 (prime demodulator number).
yyy.y = .5 to 127 (time in increments of .5 seconds), AUTO, or NONE.
B.3.2.5 Backup Demodulator Active
Command:
<add/DA_Bx_yyy”cr”
Response:
>add/DA_Bx_yyy”cr””lf”]
Status Only:
<add/DA_Bx”cr”
Response:
>add/DA_Bx_yyy”cr””lf”]
Where:
x = 1 or 2 (backup demodulator number).
yyy = YES or NO.
Note: Backup number two cannot be active if the downlink transponders option is
specified to be “7”. See the “DTO_” command.