Comtech EF Data SMS-758 - Manual (Page 29)

MN/SMS758 Rev. 3 2–1
Chapter 2.
INSTALLATION
This chapter consists of:
•
Unpacking instructions
•
System installation
•
System requirements
•
Description of the external connections
!
CAUTION
The equipment contains parts and assemblies sensitive to damage by
Electrostatic Discharge (ESD). Use ESD precautionary procedures when
touching, removing, or inserting printed circuit boards.
2.1 Unpacking
The switch and manual are packaged in pre-formed, reusable, cardboard cartons
containing foam spacing for maximum shipping protection. To remove the switch:
!
CAUTION
Do not use any cutting tool that will extend more than 1” into the container
and cause damage to the modem.
1. Cut the tape at the top of the carton (indicated by OPEN THIS END).
2. Remove the cardboard/foam space covering the switch.
3. Remove the switch, manual, and power cord from carton.
4. Save the packing material for storage or reshipment purposes.
5. Inspect the equipment for any possible damage incurred during shipment.
6. Check the equipment against the packing list to ensure the shipment is correct.
7. Refer to Section 2.2 for further system installation instructions.