Comtech EF Data SMS-758 - Manual (Page 163)

SMS-758 Modem Protection Switch Remote Control Operation
MN/SMS758 Rev. 3 B–19
Character “f”: Modulator operational fault status character 2.
Bit 6 = 1 always.
Bit 5 = Prime modulator #7 backup operational fault.
Bit 4 = Prime modulator #8 backup operational fault.
Bit 3 = Reserved.
Bit 2 = Reserved.
Bit 1 = Reserved.
Bit 0 = Reserved.
Character “g”: Demodulator operational fault status character 1.
Bit 6 = 1 always.
Bit 5 = Prime demodulator #1 backup operational fault.
Bit 4 = Prime demodulator #2 backup operational fault.
Bit 3 = Prime demodulator #3 backup operational fault.
Bit 2 = Prime demodulator #4 backup operational fault.
Bit 1 = Prime demodulator #5 backup operational fault.
Bit 0 = Prime demodulator #6 backup operational fault.
Character “h”: Demodulator operational fault status character 2.
Bit 6 = 1 always.
Bit 5 = Prime demodulator #7 backup operational fault.
Bit 4 = Prime demodulator #8 backup operational fault.
Bit 3 = All demodulators on downlink #1 fault.
Bit 2 = All demodulators on downlink #2 fault.
Bit 1 = All demodulators on downlink #3 fault.
Bit 0 = All demodulators on downlink #4 fault.
Character “i”: Demodulator operational fault status character 3.
Bit 6 = 1 always.
Bit 5 = All demodulators on downlink #5 fault.
Bit 4 = All demodulators on downlink #6 fault.
Bit 3 = All demodulators on downlink #7 fault.
Bit 2 = Reserved.
Bit 1 = Reserved.
Bit 0 = Reserved.
Character “j”: Modulator configuration verify fault status character 1.
Bit 6 = 1 always.
Bit 5 = Prime modulator #1 configuration verify fault.
Bit 4 = Prime modulator #2 configuration verify fault.
Bit 3 = Prime modulator #3 configuration verify fault.
Bit 2 = Prime modulator #4 configuration verify fault.
Bit 1 = Prime modulator #5 configuration verify fault.
Bit 0 = Prime modulator #6 configuration verify fault.
Character “k”: Modulator configuration verify fault status character 2.
Bit 6 = 1 always.
Bit 5 = Prime modulator #7 configuration verify fault.
Bit 4 = Prime modulator #8 configuration verify fault.
Bit 3 = Backup modulator #1 configuration verify fault.
Bit 2 = Backup modulator #2 configuration verify fault.
Bit 1 = Reserved.
Bit 0 = Reserved.