Comtech EF Data SMS-758 - Manual (Page 41)

SMS-758 Modem Protection Switch Operation
MN/SMS758 Rev. 3 3–3
The base levels of this tree-structured front panel menu are as follows:
•
ID menu displayed at power-on
•
SYSTEM and MODEM SETUP menu
•
CONFIGURATION and VERIFICATION menu
•
FAULT menu
•
MODE menu
•
STATUS display
The ID menu displays the model number of the switch and version of firmware installed.
The [NEXT], [PREV], [F1], [F2], and [ENT] keys control the menus, and allow menu
selections.
Some display messages have menu options on the right side, aligned with the [F1] and
[F2] keys. Pressing either of those keys directs the display to the selected menu.
The operator can move forward or backward through the selected menu by pressing the
[NEXT] or [PREV] keys.
The switch beeps in response to keypad inputs:
•
One beep acknowledges a valid entry, with the appropriate action being taken.
•
Two beeps indicate that the entry was invalid, and no action was taken.
Once the correct menu is selected, the operator can press the [ENT] key to enter, change,
or view the functions within that menu.
Refer to Figure 3-2 for details of the menu hierarchy and displays.
The display maps show the menus available with independant mod/demod firmware
installed (version 6.x.x). Modem switching firmware (version 5.x.x) has slight
differences in the “Modem Setup” and “Local Mode” menus.
In the “Modem Setup” menu:
•
The “Select Interface” menu with the options 7, 8, and 9 does not exist.
•
“Mod Priority” and “Demod Priority” are conbined into “Modem Priority.”
•
“Demod Delay” and “Mod Delay” are combined into “Modem Delay.”
In the “Local Mode” menu,
•
The “Select Mod or Demod” menu does not exist.