QuickLabel 482 Pronto! User Manual
Page 103
Pronto! 482/486/682/863
8-13
1
For this operation mode, the spring must be removed from the rewind
axle as described in the previous chapter.
Loosen the screws and remove the spring.
2
Use a cardboard core (20) which is about .04 in (1 mm) wider than the
label strip.
3
Put the first axle adapter (4) onto the rewind axle (15) and slide it up to
the disc (14).
Tighten the knurled screw (19).
4
Put the second axle adapter (4) onto the rewind axle and slide it towards
the first adapter until the clearance between the outer edge of it and the
disc (14) is a little less than the width of the cardboard core.
Tighten the knurled screw (19).
5
Slide the cardboard core (20) over the two adapters (4) until it is touching
the disc (14).
6
Feed the label strip over the guide bar (16) and under the roller (18) up to
the cardboard core (20).
Ensure that the label strip is even with the disc (14).
7
Using adhesive tape or label, affix the end of the label strip to the
cardboard core.
Consider the required method of rewinding:
•
The broken line is valid for inside wound labels.
•
The full line is valid for outside wound labels.
8
Slide the flange (2) onto the rewind axle (15) until it stops
9
Tighten the knurled screw (17) on the flange.
10
The rewinder is ready for operation. If the printer carries out a paper feed
the rewinder also starts to operate.