QuickLabel 482 Pronto! - Manual (Page 75)

Pronto! 482/486/682/863 6-1
Chapter 6:
Loading media
This chapter contains the following sections:
• Opening and closing the support bracket Pronto! 863 - Describes how to
open/close the support bracket on the Pronto! 863 printer
• Loading labels from a roll - Describes how to load label rolls
• Removing the wound roll - Describes how to remove wound rolls from
the printer
• Loading fanfold labels - Describes how to load fanfold labels
• Loading transfer ribbon - Describes how to load transfer ribbon
• Setting the feed path of the transfer ribbon - Describes how to reduce
ribbon wrinkling by adjusting the feed path
• Removing and installing the rewind guide plate, dispense plate or tear-
off plate - Describes how to install and remove components for use in
another operating mode
• Removing and installing the locking system - Describes how to remove
and install the locking system
For adjustments and simple installation work, use the accompanying
hexagonal wrench located in the bottom section of the print unit. No other
tools are required for the work described here.