QuickLabel 482 Pronto! - Manual (Page 143)

Pronto! 482/486/682/863 8-53
signal is active. On inactive pause signal the printer continues the print
job at the pause position.
XPSE is active when current flows between PIN1 and PIN9.
• XFEH - External error
An error has occurred on the external device.
The label print is stopped and the display of the printer shows the
message "External error". After the error is corrected, it is possible to
press the PAUSE key or alternatively send the XPSE signal and the print
job will continue. The last label printed before the error occurred will be
repeated.
Pressing the CANCEL key will stop the print job and the printer will be
reset. XFEH is active when current flows between PIN2 and PIN10.
• XEDG - No existing print job
There is no print job currently available.
In this state the contact between PIN5 and PIN14 is opened.
• XDNB - Printer is not ready
An error has occurred on the printer.
The label print is stopped and the details and type of error can be read
from the printer display ('Ribbon out'; 'Paper out'; 'No label').
After the error is corrected, it is possible to press the PAUSE key or
alternatively send the XPSE signal and the print job will be continued.
The last label printed before the error occurred will be repeated.
Pressing the CANCEL key will stop the print job and reset the printer.
XDNB is active if the contact between PIN6 and PIN14 is opened.
• XEDST - Print of label has started
The printing of a label is indicated with a 20ms pulse.
XEDST is active if the contact between PIN7 and PIN14 is opened.
• GND - Ground (0V)
• RXPSE - Reverse line of the pause signal XPSE
Note: During a print job you can send the pause signal XPSE to the
printer alternatively to pressing the PAUSE key.