QuickLabel 482 Pronto! - Manual (Page 192)

11-8 Cleaning and basic maintenance
Removing the printhead
1 Turn lever (10) counterclockwise to lift the printhead.
2 Remove labels and transfer ribbon from the printer.
3 Remove hexagonal wrench (11) from its retainer.
4 Lightly keep printhead mounting bracket (9) on the print roller with one
finger and screw out screw (8) with the hexagonal wrench and remove it
and the washer.
5 Swivel printhead mounting bracket (9) upward.
6 Remove printhead from the printhead mounting bracket (9) if necessary.
7 Loosen both plug connections (2, 3) on the printhead and set printhead
down on a clean, soft surface.
Installing the printhead
1 Attach plug connections (2, 3).
2 Position printhead in printhead mounting bracket (9) in such a way that
the pins (6) are secured in the corresponding holes in the printhead
mounting bracket (9).
3 Lightly keep printhead mounting bracket (9) on the print roller with one
finger and check for correct positioning of the printhead mounting
bracket (9).
4 Screw in screw (8) with washer with the hexagonal wrench and tighten it.
5 Reload labels and transfer ribbon (see Chapter 6: Loading media).
5
8
9
10
11
3 6
6
2
1
4
7 4