QuickLabel 482 Pronto! - Manual (Page 164)

9-12 CU4 Cutter Accessory
2 Grease the circular blade according to Lubrication on page 9-10.
Changing the Blades
1 Turn the printer off and dismount the cutter from the printer.
2 Turn the axle (3) of the circular blade (2) with a screwdriver for slotted
head screws (slot width 7 mm) so that the inscription (1) of the blade
points downward.
In this position the set screw (4) on the gear-wheel circular blade can be
achieved from the rear of the cutter. Loosen this set screw (4) a few turns.
3 Hang out the spring (13) on the bearing plate (15) and the linear blade
(11).
4 Unscrew the screws (8) and remove the bearing plate (15) sideways.
5 Take the circular blade (2) out of its bearing (5). Now you can slacken the
spring (6) of the linear blade.
Caution: When you have loosen the screw (2) the circular blade has to be
repositioned after cleaning as described in section Adjusting the Circular Blade
and the Clock Wheel on page 9-14.
Note: Attend on the washers (A, B, C) for the circular blade (2) and the
linear blade (11) when you dismount the bearing plate. The washers
could get lost because of their smallness.
Caution: Always keep the linear knife with one hand (11) in its position
and push its axle slightly to the mounting plate (9) of the cutter, because
the spring (6) is tense.