QuickLabel 482 Pronto! User Manual
Page 105
Pronto! 482/486/682/863
8-15
1
Use a cardboard core (20) which is about .04 in (1 mm) wider than the
label strip
2
Put the cardboard core (20) onto the rewind axle (15).
3
Feed the label strip over the guide bar (16) and under the roller (18) up to
the cardboard core (20).
Ensure that the label strip is even with the disc (14).
4
Using adhesive tape or label, affix the end of the label strip to the
cardboard core.
Consider the required method of rewinding:
•
The broken line is valid for inside wound labels.
•
The full line is valid for outside wound labels.
5
Slide the flange (2) onto the rewind axle (15) until it stops.
When using small labels it is possible that the cardboard core not covers
the spring over the whole length. In this case the groove on the flange
must be aligned so that it fits on the spring of the rewind axle.
6
Tighten the knurled screw (17) on the flange.
7
The rewinder is ready for operation. If the printer carries out a paper feed
the rewinder also starts to operate.