QuickLabel 482 Pronto! - Manual (Page 243)

Pronto! 482/486/682/863 16-9
Remove ribbon Transfer ribbon is loaded
although the printer is set
to direct thermal printing for direct thermal
printing remove ribbon
for thermal transfer
printing set the printer in
the configuration or in
the software to transfer
printing
Structural err. Error in directory of the
memory card, non-secure
data access Reformat memory card.
Unknown card Memory card not
formatted
Memory card type not
supported Format card,
use another card type.
USB error
Device stalled USB device is detected,
but does not function Do not use USB device.
USB error
Too much current USB device drawing too
much current Do not use USB device.
USB error
Unknown device USB device not
recognized Do not use USB device.
Voltage error Hardware error Switch printer off and on
again.
If it occurs again
→
Service.
The voltage which has
failed is displayed. Please
note this.
Write error Hardware error Repeat write attempt.
Reformat card.
Write protected Write protection of the
PC card is activated. Deactivate write
protection.
Wrong revision Error when loading a
new firmware version.
Firmware does not work
with hardware version Load appropriate
firmware.
Error message Cause Error recovery