QuickLabel 482 Pronto! - Manual (Page 130)

8-40 Accessories
4 Secure the module (3) by tightening the screw (4).
Printer Configuration
Once the module is connected to the printer it will be recognized by the
printer automatically.
The printer can be configured to suit the individual requirements of peel-off
mode in the Setup. When the module is installed, the “Demand sensor” menu
will appear.
In the menu Setup >> Print parameters the method of backfeed for the peeloff
mode can be selected.
• Peel position - This parameter allows for adjustment of the presentation
position of the printed label on the dispense plate. Peel position with the
Note: The power supply of the module is made by the peripheral port of the
printer. Connecting an external voltage at the modules peripheral interface
could damage the module.
Setup >> Machine param. >> Demand sensor
Peel position Shift the position of the dispensed label
relative to the dispensing edge
Default: 0,0 mm
+9,9
...
-9,9
Backfeed delay Delay time between removing the label from
the peel position and the backfeed of the label.
Default: 250 ms
50 ms
...
0 ms
in 50 ms
increments
Limit peel-off
spd. Limitation of the print speed in the spd. peel-
off mode to 100 mm/s
Default: Off
Off
On
Setup >> Print parameters
Backfeed Method of backfeed when using peel-off
mode or cut mode
Default: smart
smart
always