QuickLabel 482 Pronto! - Manual (Page 124)

8-34 Accessories
Insertion of the Prepared Winding Axle
Unwinding from a roll with outside wound labels
Unwinding from a roll with inside wound labels
• Hang up the axle with material in the unwinder. When hanging up, the
flange with the knurled screw has to be in front.
• Feed the label strip (14) over the swing arm (7) and the rewind axle (15) to
the printer.
Note: Pay attention to the different positions of the unwinder. The position
depends on the winding of the material rolls as described in Placing the
Unwinder on page 8-29.