3–preparation, Powering the unit, Using aa batteries – Teac DR-2D User Manual
Page 25: Using an ac adaptor (sold separately)
TASCAM DR-2d
25
Powering the unit
The DR-2d can be operated using two AA batteries or an
optional AC adapter (PS-P520). This unit can use alkaline or
Ni-MH batteries.
Using AA batteries
Open the battery compartment cover on the back of the unit,
install the batteries with the correct +/– orientation and close the
battery compartment cover.
When using AA batteries, set the type of battery in order to
accurately show the amount of power remaining and allow the
unit to accurately determine whether power is available for
proper operation. (See “Setting the type of batteries” on page
76.)
NOTE
Manganese dry cell batteries (R6) cannot be used with this
•
unit.
This unit cannot recharge Ni-MH batteries. Use a
•
commercially available recharger.
The included alkaline batteries are for confirming
•
operation of the unit and might not last very long.
Using an AC adaptor (sold separately)
Connect to the PS-P520 AC adaptor (sold separately) to the
DC
IN 5V connector as shown in the illustration.
AC outlet
DC plug
TASCAM
PS-P520
(not supplied)
3–Preparation