Teac DR-2D - Manual (Page 38)

38
TASCAM DR-2d
Adjusting the input level
The following procedures explain how to use the Record Screen
to set the levels.
1 Press the RECORD key to begin recording standby.
The record indicator flashes red and the Record Screen
appears.
2 Use the INPUT LEVEL (+, –) keys on the left side of the
unit to adjust the input level.
The L/R meter shows the input level.
If the input is too high, the PEAK indicator to the right of
the dispaly lights and line remains at the right end of the
indicator bar.
Set the level as high as possible without causing the
PEAK
indicator to light red when the loudest sounds occur.
When you have selected MIC as the input source and are
using the built-in microphone or
MIC IN jack, if you find
the level to be too low even when the INPUT volume is at
maximum, use the Input Setting Screen to set the
GAIN
item to MID or HIGH . (See “Setting the input functions” on
page 35.)
CAUTION
When using a microphone to record, be aware of the
following.
If you set the GAIN item on the INPUT SETTING screen to MID
or HIGH, distorted sounds might be recorded even when the
PEAK indicator does not light.
When adjusting the input level, first set the GAIN item on the
INPUT SETTING screen to LOW, and then use the INPUT LEVEL
(+/−) keys to adjust it.
4–Recording