Teac DR-2D - Manual (Page 30)

30
TASCAM DR-2d
Preparing an SD card for use
In order to use an SD card in this unit, you must format it first.
1 Confirm that an SD card is installed and turn the power
ON.
2 The following message appears when a new card or a
card formatted for use with another device is installed in
the unit.
3 Press the ENTER/MARK key to start formatting.
4 When formatting ends, the Home Screen opens.
You can also reformat the card in this unit at any time. (See
“System Settings and Formatting” on page 75.)
CAUTION
Please use a PS-P520 AC adapter (sold separately) or make •
certain that there is sufficient remaining battery power
when formatting a card.
Formatting a card erases all the data on it.
•
Card write protection
SD cards have protect switches that prevent writing new data to
them.
Unprotected Protected
If you slide the protect switch to the “LOCK” position, file
recording and editing is not possible. Move the switch to the
unlocked position in order to record, erase and otherwise edit
data on the card.
3–Preparation