Teac DR-2D - Manual (Page 29)

TASCAM DR-2d
29
CAUTION
Always use the /HOME [ª] key to shutdown the unit.
Do not remove the batteries or disconnect the power cable
accidently while the unit is operating. If you do so, the unit
cannot shut down properly and all recordings, settings and
other data will be lost. Lost data cannot be restored. We
recommend that you also save the data manually often.
Inserting and removing SD cards
Inserting the SD card
1 Open the SD slot cover on the left side panel.
2 Insert the SD Card into the slot as shown in the following
illustration until it clicks into place.
NOTE
An SD card is already installed when the unit is shipped from
the factory. If you want to use this card to record and play
tracks, there is no need to reinstall it.
Removing the card
1 Open the SD slot cover on the left side panel.
2 Push the SD card in gently and it should eject.
CAUTION
Do not remove the SD card from the unit when it is •
connected to a computer by USB.
SD cards that meet SD or SDHC standards can be used with
•
this unit.
A list of SD cards that have been confirmed to work with
•
this unit can be found on our website (http://www.tascam.
com).
3–Preparation