Teac HS-20 - Manual (Page 21)

TASCAM HS-20
21
3 – Preparation
Inserting and removing SD and CF
cards
Inserting SD/CF cards
Insert an SD/CF card into the SD card slot or CF card slot on the
front of the unit in order to use it for recording and playback.
NOTE
SD/CF cards can be inserted whether the unit is ON or OFF.
1. Pull the card slot cover forward to open it.
2. Insert the SD/CF card with the correct orientation.
With the labeled side up, insert the end with the connector
completely.
3. Close the cover.
NOTE
If you cannot close the cover of the card slot, remove the SD/
CF card and then reinsert the card.
If using a CF card, remove the CF card, press the square
button to the right of the slot and then reinsert the card.
Removing SD/CF cards
Turn the unit OFF or stop operations before removing an SD/CF
card.
CAUTION
Never remove an SD/CF card during recording, playback or
any other operation that accesses the card. Doing so could,
for example, cause recording errors, loss of recorded data,
and sudden loud noises to be output through monitoring
equipment, which could result in damaged equipment and
hearing loss.
1. Pull the card slot cover forward to open it.
2. If using an SD card, press the card into the slot slightly and
release it to bring the card out.
If using a CF card, press the square button to the right of the
CF card slot to bring the button out. Press the square button
in again to partially eject the CF card.
3. Pull the SD/CF card out by hand.