Teac HS-20 - Manual (Page 58)

58
TASCAM HS-20
8 – Take mode
4. Touch the MENU button in the take selection screen to open
the pull-up menu.
5. Touch the LOAD button in the pull-up menu.
6. When a confirmation message pop-up appears, touch the
OK button or press the DATA dial.
After loading completes, the Home Screen opens and
playback will be paused at the start of the loaded take.
NOTE
You can also press the e button for a take to load it.
In this case, no pop-up window appears, and the take
selection screen remains open after loading (the Home
screen does not reopen.)
CAUTION
If the recording sampling frequency setting and the
playback file sampling frequency are different, the
following pop-up will appear while the unit switches to the
playback file sampling frequency.
Setting input monitoring
Turn input monitoring off during playback.
If input monitoring is on, sound from the input connectors will
be output through all the output connectors of this unit.
1. Touch the INPUT MONITOR button on the Home Screen to
open a pull-up with the input monitoring ON/OFF buttons.
2. If input monitoring is on (ON button blue), touch the OFF
button to turn it off (OFF button blue).
Playback control in take mode
Press the PLAY key to start playback.
Press the PAUSE key to start playback standby.
Press the PLAY key to end recording standby.
Press the STOP key to stop playback.
Press the . [MARK.] key or // [MARK/] key to
switch takes.
Press and hold the m [
] key or , [ ] key to search
backward or forward.
Press the . [MARK.] or / [MARK/] key while
pressing and holding the SHIFT key to move between marks.
Press and hold the m [
] key or , [ ] key while
pressing and holding the SHIFT key to search at high-speed.
NOTE
• On the PLAY SETUP screen, you can set whether only the
currently selected take is played or whether all the takes
within the current folder are played. You can also enable
and disable repeat playback. (See “Playback settings (PLAY
SETUP)” on page 80.)
• Playback functions can also be controlled through through
the PARALLEL connectors.
Using the call function in playlist mode
Press the CALL [CHASE] key to locate to the point where
playback was last started from playback standby (call point) and
put the unit in playback standby mode.
Using the flash start function in take mode
Using a TASCAM RC-HS20PD (sold separately) or other remote
controller, flash start playback is possible.
For details, see “Flash start function” on page 109.