Installing click supervisor – Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide User Manual
Page 24
In this chapter
˽ Installing Click Supervisor
˽ Microsoft .NET Framework
4
Once your Click devices are installed and wired, the next step is to install Click Supervisor,
a computer program that will help you work with your Click modules. Most Click 500 ap-
plications can be configured and monitored to some extent using the buttons and LEDs on
the module, but certain devices can be fine-tuned using Click Supervisor. These computer-
programmable devices include the following:
˽
Click 512 – Vehicle Alert
˽
Click 513 – Traffic Alert
˽
Click 514 – Event Logger
In addition, any custom applications developed on the Click 500 platform have the capabil-
ity of working with Click Supervisor, if that is what the developer decides to do.
Note
If you are running Windows® Vista, you must run Click Supervisor in XP Service Pack
2 compatibility mode. To switch to this mode, right-click on the Click Supervisor icon
and select
Properties from the drop-down menu. Go to the Compatibility tab. Under
Compatibility mode, click the
Run this program in compatibility mode for: check-
box. This will enable the drop-down menu, allowing you to select Windows XP (Ser-
vice Pack 2). Hit
OK.
Installing Click Supervisor
4