Wavetronix Click 500 (programmable controller) (CLK-500) - User Guide - Manual (Page 26)

CHAPTER 4 • INSTALLING CLICK SUPERVISOR 25
Figure 4.2 – Selecting an Installation
If you select Computer, the program will go through the steps outlined in the next section,
Installing Click Supervisor on a PC. If you select Pocket PC, the program will go through
the steps in the section titled Installing Click Supervisor on a handheld computer. If you
select both, the program will go through both installation processes, beginning with install-
ing on the PC.
Note
Although the software can be installed on most handhelds, because of constantly
changing handheld technologies, Wavetronix can only offer technical support on the
handheld in the kit, which is a Socket Mobile 650.
Installing Click Supervisor on a PC
Follow these steps to install Click Supervisor on a PC:
1 On the screen shown in Figure 4.2, click the checkbox labeled Computer and then
select Next > >.
2 Select an installation location. The default location provided is normally “C:\Program
Files\Wavetronix.” Click Browse to choose another location (see Figure 4.3).