Yaskawa VS-616PS5 Series Programming Manual - Manual (Page 107)

VS-616PS5 Programming Manual 107
F4-06 Analog output channel 2 bias - ±109.2 0.0 A
F5 DO-02 Setup
F5-01 DO-02C digital output channel 1 selection
0: During RUN 1
1: Zero speed
2: Fref/Fout agree 1
3: Fref/Set agree 1
4: Frequency detection 1
5: Frequency detection 2
6: Inverter Ready
7: DC bus undervoltage
8: Baseblock 1
9: Option reference
A: Remote operation
B: Torque detection 1 (N.O.)
C: Loss of reference
D: DB overheat
E. Fault
F: Not used
10: Minor fault
11: Reset command active
12: Timer output
13: Fref/Fout agree 2
14: Fref/Set agree 2
15: Frequency detection 3
16: Frequency detection 4
17: Torque detection 1 (N.C.)
18: Torque detection 2 (N.O.)
19: Torque detection 2 (N.C.)
1A: Reverse direction
1B: Baseblock 2
1D: Regenerating
1E: Restart enabled
1F: Overload (OL1)
20: OH prealarm
30: Current/Torque limit
31: Speed limit
37: During RUN 2
- 0~FF 0 A
F5-02 DO-02C digital output Channel 2 selection
(same as F5-01)
- 0~3F 1 A
F6 DO-08 Set-up
F6-01 DO-08 digital output selection
0: 8-channel Individual 1: Binary Output
- 0/1 0 A
F8 PG-P2/H2 Set-up
F8-01 Speed feedback method selection
0: Encoder inputs 1: Hall sensor input
- 0/1 1 Q
F8-02 Pulse train moving average value
0=1 Scan (5msec)
- 0-50 0 B
F9 CP-916 Set-up
F9-01 External fault input level from communication option - 0/1 0 A
F9-02 External fault from communication level - 0/1 0 A
F9-03 Operation at external fault input from communication option
0: Ramp to stop 2: Fast-stop
1: Coast to stop 3: Alarm only
- 0~3 1 A
No. Parameter Description Unit Setting Range Default
Access
Level
User
Setting
Appendix
VS-616PS5 Parameter List