Yaskawa VS-616PS5 Series Programming Manual - Manual (Page 78)

78 VS-616PS5 Programming Manual
Section H: Control Circuit Terminal Parameters
H4 Analog Outputs
H4 Analog Outputs
The VS-616PS5 has two analog outputs, for the external monitoring of drive condi-
tions such as output speed, output current, PID feedback and others.
Selects the analog output monitors for terminal 21.
The resolution of terminal 21 is 9 bits plus a sign bit.
Setting Range: ±300.0%
Factory Default: 1.0
Sets the terminal 21 output gain for the analog output monitors. To obtain the output
level, multiply the monitor output level % by the gain value set in this parameter, (H4-
02).
H4-01 Terminal 21 Analog Output Selection B
Setting Description
1 Speed reference
2 Output Speed (factory default)
3 Inverter output current
5 Motor speed
6 Output voltage
7 DC bus voltage
8 Output power
9 Torque reference (internal)
15 External terminal 13 input voltage
16 External terminal 14 input voltage
17 External terminal 16 input voltage
18 Motor secondary current (Iq)
19 Motor excitation current (Id)
20 Primary Speed after SFS
21 Speed controller ASR input
22 Speed controller ASR output
27 qAxis current control reference
28 dAxis current control reference
29 Voltage limit control output
30 qAxis current control output
31 dAxis current control output
32 Output voltage reference (V
q
)
33 Output voltage reference (V
d
)
45 External torque reference
46 Torque compensation value
49 Control section software number
50 Speed detection PG counter value
53 PID feedback
H4-02 Terminal 21 Analog Output Gain B