Configuration sets – Yaskawa MotionWorks IEC Hardware User Manual
Page 113
Advertising
MotionWorks IEC Hardware Configuration – 2013-03-26
110
Configuration Sets
The Configuration Sets page contains a listing of all the XML configuration
files on the controller. The disco folder contains files that were created when
the controller powered up and discovered devices on the MECHATROLINK
network and other I/O connected to the controller. The startup folder is
created when the Hardware Configuration is online and saved by the
user. This is the only configuration that can be run successfully with an IEC
application. This page and the files listed are strictly for troubleshooting
purposes and should not be edited by the user.
Advertising