Yaskawa MotionWorks IEC Hardware - Manual (Page 132)

MotionWorks IEC Hardware Configuration – 2013-03-26 129
Hex Code Description
ErrorClass AxisErrorID ErrorClass+AxisErrorID output from
MC_ReadAxisError
AlarmID AlarmID output from Y_ReadAlarm
positive direction. The axis may not be moved again
until the alarm condition is cleared.
motionKernel 3202 0006 Axis Coordinate System: The command acceleration
was greater than the allowable range for the axis in the
negative direction. The axis may not be moved again
until the alarm condition is cleared.
motionKernel 3202 0007 Axis Coordinate System: The command torque was
greater than the allowable range for the axis in the
positive direction (overtorque). The axis may not be
moved again until the alarm condition is cleared.
motionKernel 3202 0008 Axis Coordinate System: The command torque was
greater than the allowable range for the axis in the
negative direction (overtorque). The axis may not be
moved again until the alarm condition is cleared.
motionKernel 3202 0011 Joint Coordinate System: The command position was
outside the allowable range for the axis in the positive
direction (positive overtravel). The axis may not be
moved again until the alarm condition is cleared. After
the alarm is cleared, it is permissible to execute a
move which brings the axis back toward the allowed
region, even though the axis is probably still outside
the allowed region. Any move which pulls the axis
further away from the allowed region will re-trigger the
alarm.
motionKernel 3202 0012 Joint Coordinate System: The command position was
outside the allowable range for the axis in the negative
direction (negative overtravel). The axis may not be
moved again until the alarm condition is cleared. After
the alarm is cleared, it is permissible to execute a
move which brings the axis back toward the allowed
region, even though the axis is probably still outside
the allowed region. Any move which pulls the axis
further away from the allowed region will re-trigger the
alarm.
motionKernel 3202 0013 Joint Coordinate System: The command speed was
greater than the allowable range for the axis in the
positive direction (overspeed). The axis may not be
moved again until the alarm condition is cleared.
motionKernel 3202 0014 Joint Coordinate System: The command speed was