Yaskawa JAPMC-MC2303-E - Manual (Page 41)

3
Mounting and Starting the Module
3.3 Setting the Communication Manager
3.3.2 Setting the Communication Manager
3-11
( 2 ) Setting the Ethernet Communication Port
These settings are required to perform engineering via the 10Base-T communication port (Ethernet) of the 218IF-01
Module. For Ethernet connection, a general-purpose Ethernet board or PCMCIA Ethernet card must be mounted on the
personal computer. Prior to make settings, the IP address of the personal computer must be set.
[ a ] Mounting an Ethernet Card
Mount a general-purpose Ethernet board or PCMCIA Ethernet card on the specified connector of the personal com-
puter. Also, install the driver provided with the Ethernet card.
[ b ] Setting the IP Address
Prior to make settings for Ethernet connection, the IP address of the personal computer must be set. Set the IP address
using the following procedure.
ΠMake the following settings with the LAN cable connected.
1.
Click the Windows Start Button and select Settings - Control Panel - Internet Options.
The Internet Properties Dialog Box will be displayed.
2.
Click Connections Tab to display the tab page. Click the LAN Settings... Button.
The Local Area Network (LAN) Settings Dialog Box will be displayed.
3. Check that the Automatically detect settings Check Box is cleared, and click the OK Button to close
the dialog box.