Rose Electronics Orion X-series - Manual (Page 11)

Orion X Installation and Operations Manual 3
About This Manual
This manual covers the installation, configuration, and operation of the Orion X System. The System
consists of three components; the Orion X switch, the extender transmitter(s), and the extender
receiver(s). This manual covers only the Orion X switch. The Installation section explains how the three
components are interconnected to form a seamless switching network. The Operations section describes
how to operate the system and the features available to make switching and maintenance simple and
easy.
Features
 Extend KVM stations and computers:
 Up to 33,000 feet (10Km) using single-mode fiber cable
 Up to 1,300 feet (400m) using multi-mode fiber cable
 Up to 450 feet (140m) using CATx cable
 Supports resolutions up to 1920 x 1200 @ 60Hz and all DVI Single-Link resolutions including High-
Definition 1080p

Intuitive OSD for easy use and configuration at each user station
 Signal input to the Orion x160 / x288 can be via CATx or Fiber cable; Signal output from the Orion
x160 / x288 can be via CATx or Fiber cable. Cable types can be mixed and matched depending on
the transmitter and receiver extender configuration.
 Each port on the Orion x160 / x288 will automatically be configured as an input or output
depending on the type of extender that is connected. If a transmitter is connected, the port
becomes an input. If a receiver is connected, the port becomes an output.

Scalable chassis allows adding additional I/O cards as system needs increase
 Switch video sources of the same resolution instantly with no delay or display blanking
 Available options:
o DVI or VGA input
o Transparent USB 2.0
o Serial
o Analog or Digital audio
o Redundant PSU
o Rack mountable (19” / 9U)
Orion X KVM standard devices with USB-HID connectors support the extension of the keyboard and
mouse ONLY; use with other HID devices (Human Interface Device) such as touch screens, graphics
tablets, barcode readers or similar USB devices may be successful – but there is no guarantee for this!
The Orion™ X KVM standard device is NOT suitable for use with other USB devices such as scanners,
web-cams, data sticks etc.
Orion X KVM standard devices support only two USB-HID devices simultaneously, keyboard and mouse
or keyboard and touch-screen, etc. but not keyboard, mouse and touch-screen simultaneously. A USB
hub is allowed, but this does not increase the number of HID devices allowed..