Rose Electronics Orion X-series - Manual (Page 61)

Orion X Installation and Operations Manual 53
Setting up CON Devices through the Java Tool
 Select Definition > CON Devices in the task area.
Figure 42. Setting up CON Devices through the Java Tool
Select between the following buttons:
Button
Function
New Open a new CON Device
Delete Delete a CON Device
Apply Confirm a created CON Device
Cancel Reject changes
> Assign selected extender units
>> Assign all available extender units
< Remove the selected extender units
<< Remove all extender units
Select between the following keyboard commands:
Function
Keyboard Command
Change assignment number of the EXT unit upwards <+>
Change assignment number of the EXT unit downwards <->
To create a new console, proceed as follows:
1. Press the New button.
2. Select if a real console (Create a real Console) or a virtual console (Create a virtual Console) is
to be created, or if a template of an existing console should be used (Choose template).
Note: A template can only be used, if there is at least one existing CON device.
3. Press the OK button.
4. Determine all parameters that are relevant for the console.
5. To confirm the new console, press the Apply button.