Rose Electronics Orion X-series - Manual (Page 90)

82 Orion X Installation and Operations Manual
To disconnect an existing connection between CON and CPU devices proceed as follows:
1. Click on the port that has to be disconnected by using the right mouse button.
2. Select the Disconnect function in the popup that appears. The connected ports will be
disconnected immediately. At the same time any other connections of extenders assigned to the
involved devices will be disconnected.
USB 2.0 Switching
Switching of USB 2.0 extenders basically works like switching of KVM extenders. There are two
possibilities for switching USB 2.0 extenders, depending on how the extenders are set up in the Matrix.
1. USB 2.0 extenders that were created and assigned to an existing device with KVM extender units.
2. USB 2.0 extenders that were created as a separate device which contains no KVM extender units.
This allows switching of USB 2.0 equipment independent of KVM devices.
Notes:
The separate switching of USB 2.0 signals requires the methods described in the section on
Extended Switching above.
When switching USB 2.0 equipment, wait until the CPU enumeration of USB 2.0 devices has been
completed before switching to the next CPU (approximately. 5-15 seconds). Failure to allow
enough time for USB 2.0 device enumeration can negatively affect the stability of the connection.